ASTM-D1404 Standard Test Method for Estimation of Deleterious Particles in Lubricating Grease

ASTM-D1404 - 1999 R19 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Estimation of Deleterious Particles in Lubricating Grease
ORDER

Price:

$55.00        


Want this as a site license?

Scope

1.1 This test method describes a procedure for the detection and estimation of deleterious particles in lubricating grease.

1.2 This test method is applicable to all lubricating greases. It can also be used to test other semi-solid or viscous materials. Grease fillers, such as graphite and molybdenum disulfide, can be tested for abrasive contaminants by first mixing them into petrolatum or grease known to be free of deleterious particles.

1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system shall be used independently of the other. Combining values from the two systems could result in nonconformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Abrasive particles; Cleanliness; Contamination-petroleum products; Deleterious particles; Lubricating grease; Particle analysis-petroleum products; Scratch test; deleterious particles-lubricating grease, detection/ estimation, test; ICS Number Code 75.100 (Lubricants, industrial oils and related products)

To find similar documents by ASTM Volume:

05.01 (Petroleum Products and Lubricants (I): D56 - D3710)

To find similar documents by classification:

75.100 (Lubricants, industrial oils and related products Including mineral oils, fluids for metal working and for temporary protection against corrosion Lubrication systems, see 21.260 Insulating oils, see 29.035.40)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D1404_D1404M-99R19

Revision Level

1999 R19 EDITION

Status

Current

Modification Type

Revision

Publication Date

June 1, 2019

Document Type

Test Method

Page Count

4 pages

Committee Number

D02.G0.01