ASTM-D1425 Standard Test Method for Evenness of Textile Strands Using Capacitance Testing Equipment

ASTM-D1425 - 2014 R20 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Evenness of Textile Strands Using Capacitance Testing Equipment
ORDER

Price:

$63.00        


Want this as a site license?

Scope

1.1 This test method covers the indirect measuring of unevenness of textile strands from tow, top, sliver, roving, and yarn produced from staple fibers and filament yarns by means of continuous runs using capacitance testing equipment.

1.2 The test method provides a value of "short-term unevenness," a single value expressing the complicated strand property that is unevenness.

1.3 The test method is applicable to all yarns, rovings, slivers, and tops, except as indicated below.

1.3.1 Low twist filament yarns should be tested only if additional twist is inserted during testing.

Note 1-In many cases, these low twist yarns tend to flatten to a ribbon while passing through the condenser of the instrument, and the recorded value of unevenness is increased above the true value.

1.3.2 Strands made from fiber blends should be tested only if blending is uniform along the strand.

Note 2-Nonuniform blending may cause a higher reading of unevenness than the true value if the component fibers differ in dielectric constant. The magnitude of the increase of unevenness readings due to nonuniform blending cannot be stated in general terms.

1.4 The values stated in either acceptable metric units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

To find similar documents by ASTM Volume:

07.01 (Textiles (I): D76 - D4391)

To find similar documents by classification:

59.080.50 (Ropes Including strings, straps, bands Wire ropes for lifting, see 53.020.30 Steel wire ropes, see 77.140.65)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D1425_D1425M-14R20

Revision Level

2014 R20 EDITION

Status

Current

Modification Type

Withdrawn

Publication Date

Feb. 1, 2020

Document Type

Test Method

Page Count

5 pages

Committee Number

D13.58