ASTM-D1447 › Standard Test Method for Length and Length Uniformity of Cotton Fibers by Photoelectric Measurement
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement of the length and length uniformity of cotton fibers by use of the Fibrograph. The test method is applicable to fibers taken from raw or partially processed cotton or some types of cotton waste, but not to fibers from blends of cotton with other fibers or to fibers recovered from cotton yarns or fabrics.
1.2 This test method covers procedures for all models of the Digital Fibrograph, hereafter referred to as Fibrograph.
Note 1--Instructions for the use of Manual and Servo Fibrograph Models were included in the text of Test Method D1447 in 1971 and previous editions.Note 2--For other methods covering the measurement of the length of cotton fibers refer to Test Method D1440.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
cotton; length; ICS Number Code 59.060.10 (Natural fibres)
To find similar documents by ASTM Volume:
07.01 (Textiles (I): D76 - D4391)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1447-07R21
Revision Level
2007 R21 EDITION
Status
Current
Modification Type
Reapproval with Ed Change
Publication Date
Jan. 12, 2021
Document Type
Test Method
Page Count
5 pages
Committee Number
D13.11