ASTM-D1611 › Standard Test Method for Corrosion Produced by Leather in Contact with Metal
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the qualitative and quantitative determination of corrosion produced by leather in contact with metal. This test method does not apply to wet blue.
1.2 The values stated in inch-pound units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 The procedure is primarily intended to evaluate chrome leather intended for use in hydraulic systems under circumstances where metal corrosion is a serious factor. A high relative humidity is used for the purpose of accelerating the results.
Keywords
corrosion; leather; metal corrosion by leather ;; ICS Number Code 59.140.30 (Leather and furs)
To find similar documents by ASTM Volume:
15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1611-12(2019)
Revision Level
2012 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
April 1, 2019
Document Type
Test Method
Page Count
3 pages
Committee Number
D31.01