ASTM-D1635 › Standard Test Method for Flexural Strength of Soil-Cement Using Simple Beam with Third-Point Loading
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the flexural strength of soil-cement by the use of a simple beam with third-point loading.
Note 1--For methods of molding soil-cement specimens, see Practice D1632.
1.2 Units--The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units, which are provided for information only and are not considered standard.
1.2.1 The converted inch-pound units use the gravitational system of units. In this system, the pound (lbf) represents a unit of force (weight), while the unit for mass is slugs. The converted slug unit is not given, unless dynamic (F = ma) calculations are involved.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
flexural strength; soil-cement; soil stabilization; ICS Number Code 93.020 (Earth works. Excavations. Foundation construction. Underground works)
To find similar documents by ASTM Volume:
04.08 (Soil and Rock (I): D420 - D5876)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
MIL-HDBK-695Rubber Products: Recommended Shelf Life
ASTM-D2240
Standard Test Method for Rubber Property—Durometer Hardness
49CFR(178-199)
Transportation
Document Number
ASTM-D1635_D1635M-19
Revision Level
2019 EDITION
Status
Current
Modification Type
Revision
Publication Date
Dec. 15, 2019
Document Type
Test Method
Page Count
4 pages
Committee Number
D18.15