Document Center is acquired by Nimonik

Scope

1.1 These test methods cover the determination of the rate at which water vapor passes through films of paint, varnish, lacquer, and other organic coatings. The films may be free films or they may be applied to porous substrates.

1.2 Two test methods are covered as follows:

1.2.1 Test Method A -Dry Cup Method, and

1.2.2 Test Method B -Wet Cup Method.

1.2.3 Agreement should not be expected between results obtained by different methods or test conditions. The method that most closely approaches the conditions of use should be selected.

1.3 The values stated in inch-pound units are to be designated as the standard. Factors for conversion are stated in 13.2.1.2 and 13.2.2.2.

1.4 This standard does not purport to address the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

permeability; permeance; perms; water vapor permeance; water vapor transmission; ICS Number Code 25.220.60 (Organic coatings)

To find similar documents by ASTM Volume:

06.01 (Paint -- Tests for Chemical, Physical, and Optical Properties; Appearance)

To find similar documents by classification:

25.220.60 (Organic coatings)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.