ASTM-D1654 › Standard Test Method for Evaluation of Painted or Coated Specimens Subjected to Corrosive Environments
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the treatment of previously painted or coated specimens for accelerated and atmospheric exposure tests and their subsequent evaluation in respect to corrosion, blistering associated with corrosion, loss of adhesion at a scribe mark, or other film failure.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
4.1 This method provides a means of evaluating and comparing basic corrosion performance of the substrate, pretreatment, or coating system, or combination thereof, after exposure to corrosive environments.
Keywords
blistering; corrosion; creepage; edge/scribe; paints/related coatings/materials; rust; undercutting;
To find similar documents by ASTM Volume:
06.01 (Paint -- Tests for Chemical, Physical, and Optical Properties; Appearance)
To find similar documents by classification:
87.040 (Paints and varnishes Including coating powders, paint coatings and protective paint systems)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-B117Standard Practice for Operating Salt Spray (Fog) Apparatus
ASTM-D3359
Standard Test Methods for Rating Adhesion by Tape Test
QPL-AMS-2644
Inspection Material, Penetrant
Document Number
ASTM-D1654-08(2016)e1
Revision Level
2008 R16(E1) EDITION
Status
Current
Modification Type
Editorially changed
Publication Date
May 1, 2017
Document Type
Test Method
Page Count
4 pages
Committee Number
D01.25