ASTM-D1970 › Historical Revision Information
Standard Specification for Self-Adhering Polymer Modified Bituminous Sheet Materials Used as Steep Roofing Underlayment for Ice Dam Protection

ASTM-D1970 - 2018 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification covers the standards for polymer modified bituminous sheet materials proposed for use as underlayment on roof eaves, or valleys, or both, to prevent leakage of shingle, tile or metal roofs from water back-up due to ice dams. The underlayment sheet shall comply with the physical requirements which include thickness, maximum load, elongation, adhesion to plywood, thermal stability, flexibility, tear resistance, moisture vapor permeance, sealability, and slip resistance. The underlayment sheet shall not crack, as well, nor be too sticky as to cause damage upon being unrolled.

ORDER

Scope

1.1 This specification covers polymer modified bituminous sheet materials intended for use as underlayment on roof eaves, or valleys, or both, to prevent leakage of shingle, tile, or metal roofs from water back-up due to ice dams.

1.2 These underlayment sheets have a sticky adhesive layer which is exposed by removal of a protective sheet. The top surface is suitable to work on during the application of the exposed roofing.

1.3 Table of Contents: 

 

Section

Scope

1

Referenced Documents

2

Terminology

3

Workmanship, Finish, and Appearance

4

Physical Requirements

5

Sampling

6

Test Methods

7

     Conditioning

7.1

     Thickness

7.2

     Maximum Load and Elongation at Break

7.3

     Adhesion to Plywood

7.4

     Thermal Stability

7.5

     Flexibility at –29°C [–20°F]

7.6

     Tear Resistance

7.7

     Moisture Vapor Permeability

7.8

     Capability to Seal Around Nail
         (Head of Water Test)

7.9

     Waterproof Integrity of Side Lap Seam
         (Head of Water Test)

7.10

Precision and Bias

8

Inspection

9

Rejection and Rehearing

10

Packaging and Package Marking

11

Keywords

12

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

ice dam protections; polymer-modifieds; self-adherings; steep roofings; underlayments;

To find similar documents by ASTM Volume:

04.04 (Roofing and Waterproofing)

To find similar documents by classification:

91.100.60 (Thermal and sound insulating materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D1970/D1970M-18

Revision Level

2018 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Dec. 12, 2018

Document Type

Specification

Page Count

6 pages

Committee Number

D08.02