ASTM-D1985 › Standard Practice for Preparing Concrete Blocks for Testing Sealants, for Joints and Cracks
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the preparation of concrete blocks used for testing of joint and crack sealants for portland cement concrete and asphaltic concrete pavements. There are numerous standard material specifications that use concrete blocks prepared according to this practice. Refer to the specific standard material specification of interest to determine which tests apply and refer to the test methods for each specific test.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information purposes only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
3.1 It is intended that this practice may be used by manufacturers, users, and testing agencies. The use of this practice establishes a uniform procedure for preparing concrete blocks for the testing of sealants. It is not intended to establish test procedures or conditions of test which are associated with each of the joint sealants.
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
91.100.30 (Concrete and concrete products Including admixtures)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1985-13
Revision Level
2013 R19 EDITION
Status
Current
Modification Type
Revision
Publication Date
June 15, 2019
Document Type
Practice
Page Count
2 pages
Committee Number
D04.33