ASTM-D2013 › Standard Practice for Preparing Coal Samples for Analysis
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the reduction and division of gross or divided samples up to and including the individual portions for laboratory analysis.
1.2 Reduction and division procedures are prescribed for coals of the following groups:
1.2.1 Group A includes coals that have been cleaned in all sizes.
1.2.2 Group B includes all other coals. Unknown coals are to be considered under Group B.
1.2.3 Group A allows smaller weight laboratory samples to be retained than Group B. These lower weights may be used for particular coals if they have been shown, by using the procedures of Annex A1.2, to give a sample preparation and analysis variance which is no more than 20 % of the total analysis variance.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are provided for information purposes only.
Keywords
coal; division; reduction
To find similar documents by ASTM Volume:
05.06 (Gaseous Fuels; Coal and Coke)
To find similar documents by classification:
73.040 (Coals Including lignites Coal products, see 75.160.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2013_D2013M-21
Revision Level
2021 EDITION
Status
Current
Modification Type
Revision
Publication Date
Dec. 8, 2021
Document Type
Practice
Page Count
13 pages
Committee Number
D05.23