ASTM-D2093 › Historical Revision Information
Standard Practice for Preparation of Surfaces of Plastics Prior to Adhesive Bonding
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes surface preparations for plastic adherends, to be used prior to adhesive bonding of test specimens. It should be noted, however, that this practice specifies only the pretreating conditions of the plastic and does not cover the preparation of test specimens, testing conditions, or evaluation of tests. These are covered in the various ASTM test methods or specifications for specific materials.
1.2 Physical Treatments (for example, sanding and solvent wiping) are used in order to remove the glossy finish and all traces of dirt, grease, mold release, or other contaminants from the bonding surfaces.
1.3 Chemical Treatments (for example, sulfuric acid-dichromate solution and sodium naphthalene complex) are used in some cases to alter chemically the surface layers of the polymer itself to improve its adhesion characteristics.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. >Specific precautionary statements are given in 6.1.
Keywords
adhesive bonding; plastic; surface preparation; ICS Number Code 83.180 (Adhesives)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2093-84
Revision Level
1984 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
June 29, 1984
Document Type
Practice
Page Count
3 pages
Committee Number
D14.40