ASTM-D2172 Historical Revision Information
Standard Test Methods for Quantitative Extraction of Bitumen From Bituminous Paving Mixtures

ASTM-D2172 - ADOPT WITHDRAWN - SUPERSEDED -- See the following: ASTM-D1097
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Methods for Quantitative Extraction of Asphalt Binder from Asphalt Mixtures
ORDER

Scope

1.1 These test methods cover the quantitative determination of bitumen in hot-mixed paving mixtures and pavement samples. Aggregate obtained by these test methods may be used for sieve analysis using Test Method C 117 and Test Method C 136.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 7.

Note 1—The results obtained by these test methods may be affected by the age of the material tested, with older samples tending to yield slightly lower bitumen content. Best quantitative results are obtained when the test is made on mixtures and pavements shortly after their preparation. It is difficult to remove all the asphalt when some aggregates are used and some chlorides may remain within the mineral matter affecting the measured asphalt content.

Keywords

bitumen content; quantitative extraction of bitumen from (hot-mixed) bituminous paving; mixtures/pavement samples; bituminous paving mixtures; quantitative extraction of bitumen from (hot-mixed) bituminous paving; mixtures/pavement samples; ICS Number Code 91.100.50 (Binders. Sealing materials); 93.080.20 (Road construction materials)

To find similar documents by ASTM Volume:

04.03 (Road and Paving Materials; Vehicle-Pavement Systems)

To find similar documents by classification:

91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)

93.080.20 (Road construction materials Including asphalts, road pavements, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D2172

Revision Level

ADOPT WITHDRAWN

Status

Superseded

Modification Type

Revision

Publication Date

Aug. 30, 2011

Document Type

Test Method

Page Count

1 page

Committee Number

D04.25