ASTM-D2258 › Standard Practice for Sampling Yarn for Testing
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes a procedure for the division of shipments of yarn into test lots and the sampling of such lots for testing.
1.2 This practice is applicable to single, plied, or cabled yarns, and cords, made of any fiber or mixture of fibers, and supported on any form of package, including beams or when in fabrics.
1.3 This practice also describes procedures for the sampling of yarns removed from woven or knitted fabrics, however, when thus sampled, the yarns are usually not representative of entire shipments, as referred to in 1.1. Consequently, the resultant sampling can only be used to determine the characteristics of the yarn and is usually not used for acceptance testing. Moreover, it should be recognized that the characteristics of yarns from fabrics may be different than the characteristics of the same yarn(s), prior to being entered into the fabric manufacturing process.
1.4 This standard provides the values in both inch-pound units and SI units. Inch-pound units is the technically correct name for the customary units used in the United States. SI units is the technically correct name for the system of metric units known as the International System of Units. The values stated in either acceptable metric units or in other units shall be regarded separately as standard. The values stated in each system must be used independently of the other, without combining in any way.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Sampling-textiles; sampling yarn for testing, practice; ICS Number Code 59.080.20 (Yarns)
To find similar documents by ASTM Volume:
07.01 (Textiles (I): D76 - D4391)
To find similar documents by classification:
59.080.20 (Yarns Including plied yarns, textured yarns, threads)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2258_D2258M-16R22
Revision Level
2016 R22 EDITION
Status
Current
Modification Type
Revision
Publication Date
March 8, 2022
Document Type
Practice
Page Count
4 pages
Committee Number
D13.58