ASTM-D2294 › Standard Test Method for Creep Properties of Adhesives in Shear by Tension Loading (Metal-to-Metal)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the creep properties of adhesives for bonding metals when tested on a standard specimen and subjected to certain conditions of temperature and tensile stress in a spring-loaded testing apparatus.
1.2 This test method is applicable to the temperature range from −55 to +260°C (−67 to +500°F).
1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 This test method is useful in research and development for comparison of creep properties of adhesives, particularly as those properties are affected by changes in adhesive formulation or expected service conditions, including temperature, moisture level, and duration of loading.
4.2 The relative size and simplicity of design of the spring-loaded apparatus permits easy portability and transfer from one environment to the next without disturbing static loads.
4.3 The relative simplicity of design with inexpensive materials permits replication of creep tests at relatively low costs.
Keywords
creep; metal-to-metal bonds; shear by tension loading;
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
IEC-60601-1Medical electrical equipment - Part 1: General requirements for basic safety and essential performance
ASTM-A370
Standard Test Methods and Definitions for Mechanical Testing of Steel Products
ISO/IEC-17025
General requirements for the competence of testing and calibration laboratories
Document Number
ASTM-D2294-96(2016)
Revision Level
1996 R16 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 15, 2016
Document Type
Test Method
Page Count
3 pages
Committee Number
D14.80