ASTM-D25 Standard Specification for Round Timber Piles

ASTM-D25 - 2012 R17 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification deals with the standards for unused round timber piles to be used either treated or untreated. This specification, however, does not cover preused piles unless the piles have the quality and design stresses equal to or greater than those prescribed herein. The piles shall be made of sound wood, free of decay, insect attacks, marine borer attack, and Limnoria damage. The piles shall also be cut above the ground swell and have a tapered tip.

ORDER

Price:

$52.00        


Want this as a site license?

Scope

1.1 This specification covers the physical characteristics of unused round timber piles to be used either treated or untreated.

1.2 This specification is not intended for preused piles unless the piles have the quality specified by this specification and design stresses equal to or greater than those derived from Method D2899.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

piles; round timber piles; timber;; ICS Number Code 79.080 (Semi-manufactures of timber)

To find similar documents by ASTM Volume:

04.10 (Wood)

To find similar documents by classification:

79.080 (Semi-manufactures of timber Including parquet, wood paving, handles, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

IPC-A-610
Acceptability of Electronic Assemblies (Hardcopy format)

IPC-A-600
Acceptability of Printed Boards

IPC-2221
Generic Standard on Printed Board Design

Document Number

ASTM-D25-12(2017)

Revision Level

2012 R17 EDITION

Status

Current

Modification Type

Reapproval

Publication Date

Oct. 1, 2017

Document Type

Specification

Page Count

8 pages

Committee Number

D07.04