ASTM-D2540 › Standard Test Method for Drop-Weight Sensitivity of Liquid Monopropellants
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the sensitivity of liquid monopropellants to the impact of a drop weight.
1.2 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
Keywords
drop-weight sensitivity; explosive sensitivity; impact test; monopropellant; liquid; propellant; liquid
To find similar documents by ASTM Volume:
15.03 (Space Simulation; Aerospace and Aircraft; Composite Materials)
To find similar documents by classification:
75.160.20 (Liquid fuels Including gasoline, diesel, kerosene, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2540-93
Revision Level
1993 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
March 15, 1993
Document Type
Test Method
Page Count
7 pages
Committee Number
F07.02