ASTM-D2562 › Standard Practice for Classifying Visual Defects in Parts Molded from Reinforced Thermosetting Plastics (Withdrawn 2024)
The following bibliographic material is provided to assist you with your purchasing decision:
This practice covers acceptance criteria for visual inspection of parts molded from reinforced thermosetting plastics by compression and transfer molding. Word descriptions of possible defects to serve as a guide for contracts, drawings, product specifications, and final inspection are presented. Different inspection requirements for grades of product quality are categorized. Each part shall be checked visually without the aid of magnification. Defects shall be classified as to type and level as prescribed.
Scope
1.1 This practice covers acceptance criteria for visual inspection of parts molded from reinforced thermosetting plastics by compression and transfer molding.
1.2 This practice presents word descriptions of possible defects to serve as a guide for contracts, drawings, product specifications, and final inspection.
1.3 This practice also categorizes different inspection requirements for grades of product quality.
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this standard.
Keywords
reinforced thermosetting plastics; visual defects;
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.120 (Reinforced plastics Materials for the reinforcement of plastics, see 59.100)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
UL-94Standard for Tests for Flammability of Plastic Materials for Parts in Devices and Appliances
BS-EN-ISO-13485
Medical devices. Quality management systems. Requirements for regulatory purposes
SOR/98-282
Medical Devices Regulations (Canada)
Document Number
ASTM-D2562-94(2015)
Revision Level
1994 R15 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Sept. 1, 2015
Document Type
Practice
Page Count
6 pages
Committee Number
D20.18