ASTM-D2669 › Historical Revision Information
Standard Test Method for Apparent Viscosity of Petroleum Waxes Compounded with Additives (Hot Melts) (Withdrawn 2004)
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This test method covers the determination of the apparent viscosity of petroleum waxes compounded with additives (hot melts). It applies to fluid hot melts having apparent viscosities up to about 20 Pa[dot]s at temperatures up to 175°C (347°F).
1.2 The values stated in SI units shall be regarded as the standard. One pascal second (Pa[dot]s) = 1000 centipoises (cP). One millipascal second (mPa[dot]s) = 1 centipoise (cgs units).Note 1-For petroleum waxes and their blends having low apparent viscosities, below about 15 mPa[dot]s, Test Method D445, is especially applicable.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Additives-petroleum products; Hot melts; Petroleum wax; Viscometers-Brookfield; Viscosity-petroleum products; apparent viscosity-petroleum waxes compounded with (hot melt) additives,; test; ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
1987 R99 EDITION
Aug. 30, 1987