ASTM-D2813 › Standard Practice for Sampling Leather for Physical and Chemical Tests
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the sampling of finished leather and fabricated leather items for physical and chemical tests. The product is grouped into lots that are randomly sampled in such a manner as to produce a representative sample of the lot. This sample may be used to determine compliance of the lot with applicable specification requirements, and on the basis of results, the lot may be accepted or rejected in its entirety.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
chemical tests; leather; lot; physical tests; sampling; unit; ICS Number Code 59.140.30 (Leather and furs)
To find similar documents by ASTM Volume:
15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
IPC-A-610Acceptability of Electronic Assemblies (Hardcopy format)
IPC-A-600
Acceptability of Printed Boards
IPC-2221
Generic Standard on Printed Board Design
Document Number
ASTM-D2813-03R21
Revision Level
2003 R21 EDITION
Status
Current
Modification Type
Revision
Publication Date
Sept. 1, 2021
Document Type
Practice
Page Count
3 pages
Committee Number
D31.07