ASTM-D2829 › Standard Practice for Sampling and Analysis of Existing Built-Up Roof Systems
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice is a guide for removing test specimens from built-up roofing systems in the field and for determining the approximate quantities of the components of that specimen (Note 1). Components determined may be:
1.1.1 Insulation components when they are part of the roof membrane system,
1.1.2 Plies of roofing felt,
1.1.3 Interply layers of bituminous material,
1.1.4 Top coating, and
1.1.5 Surfacing.
Note 1-This procedure is for the investigation of problems in existing roofs and is not intended for new construction inspection.
1.2 The values stated in SI (metric) units are to be regarded as standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary information, see 6.3.2.1.
Keywords
decking; felts; insulation; interply bituminous material; lap spacing; plies; surfacing; top coating; ICS Number Code 91.100.50 (Binders. Sealing materials)
To find similar documents by ASTM Volume:
04.04 (Roofing and Waterproofing)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2829_D2829M-07R23
Revision Level
2007 R23 EDITION
Status
Current
Modification Type
Revision
Publication Date
Sept. 7, 2023
Document Type
Practice
Page Count
5 pages
Committee Number
D08.20