ASTM-D283 › Standard Test Methods for Chemical Analysis of Cuprous Oxide and Copper Pigments
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover procedures for the chemical analysis of cuprous oxide and copper pigments.
1.2 The analytical procedures appear in the following order:
| Sections |
Total Copper | 7 |
Total Reducing Power as Cuprous Oxide | 8 and 9 |
Metallic Copper | 10 and 11 |
Cuprous Oxide | 12 |
Cupric Oxide | 13 |
Metals Other than Copper | 14 – 16 |
Chlorides and Sulfates | 17 and 18 |
Acetone-Soluble Matter | 19 |
Water | 20 |
Stability | 21 |
Coarse Particles | 22 |
Coarse Particles Insoluble in Nitric Acid | 23 |
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
3.1 This collection of test methods is used by pigment producers and paint manufacturers for process control, product acceptance, and research and development.
Keywords
chemical analysis; copper pigments; cuprous oxide pigments;; ICS Number Code 87.060.10 (Pigments and extenders)
To find similar documents by ASTM Volume:
To find similar documents by classification:
87.060.10 (Pigments and extenders)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
IPC-A-610Acceptability of Electronic Assemblies (Hardcopy format)
IPC-A-600
Acceptability of Printed Boards
IPC-2221
Generic Standard on Printed Board Design
Document Number
ASTM-D283-13(2019)
Revision Level
2013 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
June 11, 2019
Document Type
Test Method
Page Count
5 pages
Committee Number
D01.31