ASTM-D3028 Standard Test Method for Kinetic Coefficient of Friction of Plastic Solids (Withdrawn 2000)

ASTM-D3028 - 1995 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Kinetic Coefficient of Friction of Plastic Solids (Withdrawn 2000)

Scope

1.1 This test method covers the determination of sliding (kinetic) friction of plastic solids or sheeting (as moving specimens) when sliding against similar or dissimilar substances (Note 1) (as fixed specimens) through the speed range of approximately 0.10 to 3.00 m/s. The instrument used is a variable speed, variable normal-force frictionometer. ,

Note 1-The physical form for these fixed specimens should be that of rigid or self-supporting solids. Attempts to mount thin sheeting, film, foil, etc., are not recommended due to the difficulty encountered when attempting to meet the weight and concentricity requirements (see 4.1.1).

1.2 Rigid or self-supporting specimens must be machined to specified dimensions. Normally, sheeting exceeding 1.00 mm (0.040 in.) in thickness should not be tested on a mounting wheel of standard diameter.

Note 2-An error accumulation of 1% per 0.50 mm (0.020 in.) of sheeting thickness results as the standard diameter of the test surface is increased. If the resulting error is not tolerable, undersize mounting wheels can be employed.

1.3 Two testing procedures are included. Selection of a procedure is determined by the specific interests of the investigator. The procedures are:

1.3.1 Procedure A -Determination of variable-velocity kinetic coefficients, and

1.3.2 Procedure B -Determination of constant-velocity kinetic coefficients over an extended period of time.

1.4 Test data obtained by this test method is relevant and appropriate for use in engineering design.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use .

Keywords

oefficient of friction-plast; kinetic coefficient of friction of plastic solids, test, ; Plast (general); kinetic coefficient of friction of plastic solids, test,

To find similar documents by ASTM Volume:

08.02 (Plastics (II): D3222 - D5083)

To find similar documents by classification:

83.140.10 (Films and sheets Including plates)

This document comes with our free Notification Service, good for the life of the document.

This document is available in Paper format.

Document Number

ASTM-D3028-95

Revision Level

1995 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

Oct. 10, 1995

Document Type

Test Method

Page Count

9 pages

Committee Number

D20.10