ASTM-D3054 › Standard Test Methods for Analysis of Cyclohexane by Gas Chromatography (Withdrawn 2007)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the determination of the hydrocarbon impurities typically found in cyclohexane and the purity of cyclohexane by difference by gas chromatography. The absolute purity of cyclohexane cannot be determined, since trace quantities of unknowns may be present. Typical impurities in high purity cyclohexane are listed in Table 1.
1.2 These test methods are applicable to impurity concentrations in the range of 0.0001 to 0.1000 wt% and for cyclohexane purities of 98% or higher when using the internal standard procedure.
1.3 The following applies to all specified limits in this test method: for purposes of determining conformance with this test method, an observed value or a calculated value shall be rounded off to the nearest unit in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Note 2 and Section 7.
Keywords
enzene; cyclohexane-analysis of hydrocarbon impurities, by gas chromatography,; test, ; Cyclohexane; cyclohexane-analysis of hydrocarbon impurities, by gas chromatography,; test, ; Gas chromatography (GC)-paints/related coatings/materials; cyclohexane-analysis of hydrocarbon impurities, by gas chromatography,; test, ; Hydrocarbons; cyclohexane-analysis of hydrocarbon impurities, by gas chromatography,; test, ; Impurities-paints/related coatings/materials; cyclohexane-analysis ofhydrocarbon impurities, by gas chromatography,; test, ; Purity-paints/related coatings/materials; cyclohexane-analysis of hydrocarbon impurities, by gas chromatography,; test, ;
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
71.080.10 (Aliphatic hydrocarbons)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3054-98
Revision Level
1998 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Aug. 10, 1998
Document Type
Test Method
Page Count
4 pages
Committee Number
D16.01