ASTM-D3167 › Standard Test Method for Floating Roller Peel Resistance of Adhesives
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the relative peel resistance of adhesive bonds between one rigid adherend and one flexible adherend when tested under specified conditions of preparation and testing.
1.2 A variation in thickness of the adherends will generally influence the test values. For this reason, the thickness of the sheets used to make the test specimens shall be specified in the material specification. When no thickness is specified, the flexible adherend shall be 0.63 mm (0.025 in.) thick and the rigid adherend shall be 1.63 mm (0.064 in.) thick.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 Use this test method for acceptance and process control testing. This test method may be used as an alternative to Test Method D1781 when that facility is not available. This test method is considered more severe since the angle of peel is greater.
Keywords
adhesives; assemblies; bonds; laminates; metal; peel; roller;; ICS Number Code 83.180 (Adhesives)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-E1316Standard Terminology for <?Pub Dtl?>Nondestructive Examinations
MIL-STD-129
Military Marking for Shipment and Storage
QPL-AMS-2644
Inspection Material, Penetrant
Document Number
ASTM-D3167-10(2017)
Revision Level
2010 R17 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Nov. 1, 2017
Document Type
Test Method
Page Count
4 pages
Committee Number
D14.80