ASTM-D3245 › Standard Test Method for Pumpability of Industrial Fuel Oils (Withdrawn 2010)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method is intended for use on petroleum fuel oils, such as those covered in Specification D 396 Grade No 4(Light), 4, 5(Light), 5, and 6, or similar fuels.
1.2 The values stated in SI units are to be regarded as standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method is designed to give an indication of the minimum storage and minimum handling temperatures which may be used for a given fuel oil. This test method is cited in Specification D 396
Keywords
handling point; industrial fuel; pumpability; storage point; ICS Number Code 75.160.20 (Liquid fuels)
To find similar documents by ASTM Volume:
05.01 (Petroleum Products and Lubricants (I): D56 - D3710)
To find similar documents by classification:
75.160.20 (Liquid fuels Including gasoline, diesel, kerosene, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3245-03
Revision Level
2003 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
March 10, 2003
Document Type
Test Method
Page Count
4 pages
Committee Number
D02.07