ASTM-D3289 › Historical Revision Information
Standard Test Method for Density of Semi-Solid and Solid Bituminous Materials (Nickel Crucible Method)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the density of semi-solid and solid bituminous materials by weighing in air and in water.
Note 1—An alternate method for determining the density of semi-solid and solid bituminous materials is Test Method D 70. For materials which are too fluid for use of this method, use Test Method D 3142.
1.2 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
Values of density are used for converting volumes to units of mass, and for correcting measured volumes from the temperature of measurement to a standard temperature using Practice D 4311
Keywords
asphalt; bituminous material; density; ICS Number Code 91.100.50 (Binders. Sealing materials); 93.080.20 (Road construction materials)
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
93.080.20 (Road construction materials Including asphalts, road pavements, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3289-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Jan. 10, 2003
Document Type
Test Method
Page Count
3 pages
Committee Number
D04.47