ASTM-D3296 Standard Specification for FEP-Fluorocarbon Tube

Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

This specification covers the tubing that is intended for electrical, mechanical, chemical and medical applications manufactured from extrusion resins made from the copolymer of tetrafluoroethylene and hexafluoropropylene. Three types of FEP-fluorocarbon tubing are classified which are differentiated by size schedules: Type I which is tubing based upon the American wire gage, Type II which is tubing based upon fractional inch sizes, and Type III which is tubing of all other sizes. Tubings are further differentiated in accordance to its increasing wall thicknesses in classes which are Class A, Class C, Class D, and Class E. Several properties of tubing such as inside diameter, wall thickness, specific gravity, tensile strength, elongation, dielectric breakdown voltage, dimensional stability, and heat resistance shall be determined by subjecting it to different test methods.




Want this as a site license?


1.1 The tubing is intended for electrical, mechanical, chemical, and medical applications manufactured from extrusion resins made from the copolymer of tetrafluoroethylene and hexafluoropropylene (FEP-fluorocarbon). This specification is for virgin material only and does not address recycled material as it is not appropriate for FEP tubing.

Note 1: Abbreviations are in accordance with Terminology D1600.

Note 2: There is no known ISO eqivalent to this standard.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


extruded material; FEP extruded tubing; fluorocarbon tubing; fluoropolymers; melt-processible fluorocarbon polymer; polytetrafluoroethylene copolymers; thin-walled tubing;; ICS Number Code 23.040.20 (Plastic pipes)

To find similar documents by ASTM Volume:

08.02 (Plastics (II): D3222 - D5083)

To find similar documents by classification:

23.040.20 (Plastics pipes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.


Customers who bought this document also bought:

Color Chip 26493

Performance Standard for Air Chain Hoists

Tubing, Electrical Insulation Standard Wall, Extruded Polytetrafluoroethylene (PTFE)

Document Number


Revision Level




Modification Type


Publication Date

May 1, 2019

Document Type


Page Count

4 pages

Committee Number