ASTM-D3379 Standard Test Method for Tensile Strength and Young's Modulus for High-Modulus Single-Filament Materials (Withdrawn 1998)

ASTM-D3379 - 1975 R89(E1) EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Tensile Strength and Young's Modulus for High-Modulus Single-Filament Materials (Withdrawn 1998)
ORDER

Scope

1.1 This test method covers the preparation, mounting, and testing of high-modulus single-filament materials [over > 21 10 9 Pa (> 3 106 psi)] for the determination of tensile strength and Young's modulus, at room temperature.

1.2 This test method is limited to single filaments utilizing a fixed gage length at least 2000 times longer than the nominal filament diameter.

1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

tensile strength; Young's Modulus; high-modulus; single-filament; ICS Number Code 59.060.01 (Textile fibres in general)

To find similar documents by ASTM Volume:

15.01 (Refractories, Activated Carbon; Advanced Ceramics)

To find similar documents by classification:

59.060.01 (Textile fibres in general Including mixtures of fibres)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D3379-75(1989)e1

Revision Level

1975 R89(E1) EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

Feb. 28, 1975

Document Type

Test Method

Page Count

5 pages

Committee Number

C28.07