Document Center is acquired by Nimonik

Scope

1.1 These test methods cover determination of the weight per unit area of waterside deposits on heat-transfer surfaces of steam generator tubes. Two test methods are given as follows:

Sections Test Method A---Mechanical Removal 6 to 11 Test Method B---Solvent Removal 12 to 18

1.2 Neither test method is normally applicable to fire-tube boilers.

1.3 A comparison of the results obtainable with the two test methods is shown in Fig. 1.

1.4 A scope section is provided in each test method. It is the responsibility of the analyst to determine the acceptability of these test methods for each situation.

1.5 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

boiler tubes; density; deposits; steam generators; ICS Number Code 27.040 (Gas and steam turbines. Steam engines)

To find similar documents by ASTM Volume:

11.02 (Water (II))

To find similar documents by classification:

27.040 (Gas and steam turbines. Steam engines Hydraulic turbines, see 27.140)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.