ASTM-D3534 Standard Test Method for Polychlorinated Biphenyls (PCBs) in Water (Withdrawn 2004)

ASTM-D3534 - 1985 R95(E1) EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Polychlorinated Biphenyls (PCBs) in Water (Withdrawn 2004)

Scope

1.1 This test method covers the determination of certain polychlorinated biphenyls (PCBs) including: Aroclors 1221, 1232, 1242, 1248, 1254, 1260, and 1016.

1.2 The detection limit is in the range from 0.1 to 0.5 [mu]g/L for Aroclor 1254 and 1260 when analyzing 1 L of water using an electron capture detector. The detection limit is compound dependent and is also determined by instrumental sensitivity and interferences present. When using a microcoulometric or conductivity detector, the detection limit is approximately 1.0 [mu]g/L.

1.3 Precision and bias statements reflect recovery of PCB products dosed into water samples. These statements may not apply to environmentally altered PCBs.

1.4 As the precision and bias statements given may apply only to waters used, it is the user's responsibility to ensure the validity of the test method for waters of untested matrices.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Note 2.

Keywords

Aroclor elution patterns; Florisil column procedure; Gas chromatography (GC)-water; PCB (polychlorinated biphenyl); Pesticide content; Silica gel microcolumn separation; Water; Water-organic constituents; Water-pathogenic constituents; polychlorinated biphenyls (PCBs) in water, test; ICS Number Code 13.060.50 (Examination of water for chemical substances)

To find similar documents by ASTM Volume:

11.02 (Water (II))

To find similar documents by classification:

13.060.50 (Examination of water for chemical substances)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D3534-85(1995)e1

Revision Level

1985 R95(E1) EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

June 1, 1995

Document Type

Test Method

Page Count

14 pages

Committee Number

D19.06