ASTM-D3540 › Standard Specification for Primary Amyl Acetate, Synthetic (98 % Grade) (Withdrawn 2021)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers synthetic primary amyl acetate (98 % grade). The apparent specific gravity, color property, distillation range, water property, acidity, and ester value shall be tested to meet the requirements prescribed.
Scope
1.1 This specification covers synthetic primary amyl acetate (98 % grade).
1.2 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 For specific hazard information and guidance, see the supplier's Material Safety Data Sheet for material listed in this specification.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
amyl acetate; ester; solvent
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3540-12
Revision Level
2012 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Feb. 1, 2013
Document Type
Specification
Page Count
2 pages
Committee Number
D01.35