ASTM-D3588 Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels

ASTM-D3588 - 1998 R17(E1) EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels
ORDER

Price:

$63.00        


Want this as a site license?

Scope

1.1 This practice covers procedures for calculating from compositional analyses, the following properties of natural gas mixtures: heating value, relative density and compressibility factor at base conditions (14.696 psia and 60°F). It is applicable to all common types of utility gaseous fuels (for example, dry natural gas, reformed gases, oil gas (both high- and low-Btu), propane-air, carbureted water gas, and coke oven and retort coal gas) for which suitable methods of analysis as described in Section 6 are available. Calculation procedures for other base conditions are given.

1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Calculating test values; Calorific value; Carbureted water gas; Coal and coal products; Coal gas; Coke oven gas; Dry natural gas; Gaseous fuels; Manufactured gas; Propane; Reformed natural gas; Retort coal gas; Specific gravity-petroleum products; Utility gaseous fuels; calculating calorific value/specific gravity (relative density) of; gaseous fuels, method

To find similar documents by ASTM Volume:

05.06 (Gaseous Fuels; Coal and Coke)

To find similar documents by classification:

75.160.30 (Gaseous fuels Including liquefied petroleum gases Hydrogen, see 71.100.20 Natural gas, see 75.060)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

IPC-A-610
Acceptability of Electronic Assemblies (Hardcopy format)

IPC-A-600
Acceptability of Printed Boards

IPC-2221
Generic Standard on Printed Board Design

Document Number

ASTM-D3588-98R17E01

Revision Level

1998 R17(E1) EDITION

Status

Current

Modification Type

Revision

Publication Date

April 8, 2020

Document Type

Practice

Page Count

9 pages

Committee Number

D03.03