ASTM-D3647 › Standard Practice for Classifying Reinforced Plastic Pultruded Shapes According to Composition (Withdrawn 2022)
The following bibliographic material is provided to assist you with your purchasing decision:
This practice outlines a method for classifying reinforced plastic pultruded shapes according to their composition. In classifying the reinforced plastic pultruded shape according to composition, four separate aspects of the composition shall be considered: reinforced material; reinforcement type; resin type; and filler amount. The composition shall be identified by the use of four capital letters. The sequential position of each letter shall have particular significance in describing the composition.
Scope
1.1 This practice outlines a method for classifying reinforced plastic pultruded shapes according to their composition.
1.2 One objective of this practice is to provide a codification means and descriptive limits for classification.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this standard.
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.120 (Reinforced plastics Materials for the reinforcement of plastics, see 59.100)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3647-16
Revision Level
2016 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Sept. 1, 2016
Document Type
Practice
Page Count
2 pages
Committee Number
D20.18