ASTM-D3711 Historical Revision Information
Standard Test Method for Deposition Tendencies of Liquids in Thin Films and Vapors

ASTM-D3711 - 1995 R05 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Deposition Tendencies of Liquids in Thin Films and Vapors (Withdrawn 2016)
ORDER

Scope

1.1 This test method covers the determination of the tendency of liquids in thin films and of vapors to form deposits on metal surfaces. The test method applies to both petroleum-based and synthetic lubricants, hydraulic fluids, heat-transfer fluids, and related materials.

1.2 The values stated in SI units are to be regarded as the standard. In cases where materials, products, or equipment are available in inch-pound units only, SI units are omitted.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section and Annex A2.

Significance and Use

The test method shall measure the deposit formation tendencies of liquids on steel surfaces in air at 101.3 KPa (1-atm) pressure. Other surfaces and other atmospheric media may be substituted for steel and air at 1 atm provided that the substitution is noted in the test report.

Keywords

deposition tendency; deposits; thin films; vapors; ICS Number Code 75.100 (Lubricants, industrial oils and related products)

To find similar documents by ASTM Volume:

05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)

To find similar documents by classification:

75.100 (Lubricants, industrial oils and related products Including mineral oils, fluids for metal working and for temporary protection against corrosion Lubrication systems, see 21.260 Insulating oils, see 29.035.40)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D3711-95(2005)

Revision Level

1995 R05 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

Sept. 1, 2005

Document Type

Test Method

Page Count

5 pages

Committee Number

D02.L0.07