Document Center is acquired by Nimonik

Scope

1.1 These test methods cover test procedures for emulsion polymers that are used in water-based floor polishes. The term "emulsion polymers" is used primarily to denote those materials produced by regular emulsion polymerization techniques, but may be extended to those polymers that are subsequently emulsified or dispersed after polymerization. Unless otherwise noted, the tests may be used for any polymer or copolymer systems. The methods appear in the following order:

Section Sampling 4 Total solids 5 pH value 6 Apparent viscosity 7 Sediment 8 Storage stability 9 Freeze-thaw stability 10 Specific gravity 11

1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Acidity, alkalinity, pH-detergent materials; Apparent viscosity; Chemical analysis-detergent materials; Floor polish-water emulsion; Freezing and thawing-polishes; Polishes; Polymer emulsion floor polishes; Sampling-soaps/polishes; Sediment content; Solids content; Specific gravity; Specific gravity-cleaners/detergents; Stability-freeze-thaw; Storage stability; Total solids; Viscosity-apparent; sampling/chemical analysis-polymer emulsions (for use in floor; polishes), methods; ICS Number Code 83.140.01 (Rubber and plastic products in general)

To find similar documents by ASTM Volume:

15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)

To find similar documents by classification:

83.140.01 (Rubber and plastics products in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.