Document Center is acquired by Nimonik

Scope

1.1 This specification covers the general requirements for materials used in rubber seals of concentrating solar collectors. Particular applications may necessitate other requirements that would take precedence over these requirements when specified.

1.2 Design requirement pertains only to permissible deflections of the rubber during thermal expansion or contraction of the seal in use and the tolerances in dimensions of molded and extruded seals.

1.3 This specification does not include requirements pertaining to the fabrication or installation of the seals.

1.4 The values stated in SI units are to be regarded as the standard.

1.5 The following safety hazards caveat pertains only to the test methods portion, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Rubber seals; concentrating solar collectors, spec.,; Solar collectors-rubber seals; Solar heating/cooling systems-rubber seals; concentrating collectors; ICS Number Code 21.140 (Seals, glands)

To find similar documents by ASTM Volume:

09.02 (Rubber Products, Industrial - Specifications and Related Test Methods; Gaskets; Tires)

To find similar documents by classification:

21.140 (Seals, glands Seals for pipe and hose assemblies, see 23.040.80)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.