ASTM-D3794 Historical Revision Information
Standard Guide for Testing Coil Coatings

ASTM-D3794 - 2018 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Guide for Testing Coil Coatings
ORDER

Scope

1.1 This guide covers procedures for testing coil coatings. The test methods included are listed in Table 1. Where more than one test method is listed for the same characteristic, no attempt is made to indicate superiority of one method over another. Selection of test methods to be followed must be governed by the requirements in each individual case, together with agreement between the producer and user.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Significance and Use

4.1 This guide represents a collection of pertinent ASTM test methods used within the coil coatings industry. In the past coil coaters world wide depended on industry standards written by the National Coil Coating Association. That association, working cooperatively with ASTM, will no longer issue new, nor update old, standards.

Keywords

absorbance; accelerated; acetic acid; adhesion; chip resistance; chromate; coil coatings; color; cone and plate; cyclic; density; dew cycle; film thickness; fame spread; fluorescent-UV condensation; Fresnel; glass transition; hardness; humidity; impact; irradiance; Kesternich; metamerism; methods; pH; phosphate; reflectance; salt spray; solar reflectance; solids; solvent resistance; standards; Taber; T bends; transmittance; viscosity; VOC; weathering; xenon; Zahn;

To find similar documents by ASTM Volume:

06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)

To find similar documents by classification:

87.040 (Paints and varnishes Including coating powders, paint coatings and protective paint systems)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D3794-18

Revision Level

2018 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

June 1, 2018

Document Type

Guide

Page Count

11 pages

Committee Number

D01.53