ASTM-D3800M › Standard Test Method for Density of High-Modulus Fibers
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the density of high-modulus fibers and is applicable to both continuous and discontinuous fibers.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 9 for additional information.
Significance and Use
Fiber density is useful in the evaluation of new materials at the research and development level and is one of the material properties normally given in fiber specifications.
Fiber density is used to determine fiber strength and modulus both of a fiber bundle and an individual filament. These properties are based on load or modulus slope over an effective area. Fiber density may be used with lineal mass of the fiber to give an approximation of effective tow area. Tow area divided by the average number of filaments in a tow gives an approximation of the effective area of an individual filament.
Fiber density is used as a constituent property when determining reinforcement volume and void volume based on reinforcement mass and laminate density.
Keywords
Archimedes method; buoyancy method; density; fiber density: High modulus fibrous composites; Sink-float method; Archimedes method; Bouyancy method; Continuous high-modulus fibers; Density; Discontinuous high-modulus fibers; Eureka test; Fiber density; ICS Number Code 49.025.60 (Textiles)
To find similar documents by ASTM Volume:
15.03 (Space Simulation; Aerospace and Aircraft; Composite Materials)
To find similar documents by classification:
49.025.60 (Textiles Including textile glass and coated fabrics)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-D1621Standard Test Method for Compressive Properties of Rigid Cellular Plastics
ASTM-C273
Standard Test Method for Shear Properties of Sandwich Core Materials
ASTM-D2842
Standard Test Method for Water Absorption of Rigid Cellular Plastics
Document Number
ASTM-D3800M-11
Revision Level
2011 EDITION
Status
Superseded
Modification Type
Revision with Designation Change
Publication Date
Sept. 30, 2011
Document Type
Test Method
Page Count
6 pages
Committee Number
D30.03