ASTM-D3964 › Standard Practice for Selection of Coating Specimens for Appearance Measurements
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice provides a guide to selection of specimens for appearance measurement as well as a discussion of factors to be considered in their preparation for measurement. Standardized selection and presentation procedures will assist in achieving agreement between evaluations carried out in different laboratories as well as helping to achieve better correlations between visual evaluations and instrumental measurements.
Note 1 - This standard is not a practice for preparation of test panels of coatings; See Practice D 823.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
coatings; specimens; appearance; appearance measurements; ICS Number Code 87.040 (Paints and varnishes)
To find similar documents by ASTM Volume:
06.01 (Paint -- Tests for Chemical, Physical, and Optical Properties; Appearance)
To find similar documents by classification:
87.040 (Paints and varnishes Including coating powders, paint coatings and protective paint systems)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
MIL-STD-810Environmental Engineering Considerations and Laboratory Tests
MIL-STD-883
Microcircuits
MIL-HDBK-217
Reliability Prediction of Electronic Equipment
Document Number
ASTM-D3964-10R20
Revision Level
2010 R20 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
July 2, 2020
Document Type
Practice
Page Count
2 pages
Committee Number
D01.26