ASTM-D418 › Standard Methods of Testing Pile Yarn Floor Covering Construction (Withdrawn 1998)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the construction testing of machine-made woven, knitted, and tufted pile yarn floor covering both before and after an adhesive back coating, which bonds the backing fabric, has been applied.
1.2 This standard includes the following test methods:
1.2.1 Specimen preparation procedures common to Sections 7, 8, 9, 10, and 11 are presented in Annex A1, Preparing Specimens of Measured Area. Annexes A2 and A3 give examples of typical calculations for Sections 9 and 11.
1.3 The values stated in inch-pound units are to be regarded as the standard for all measurements except mass. The SI (metric) values for all measurements except mass are provided for information purposes only.
1.4 This standard may involve the use of hazardous materials, operations and equipment. It is the responsibility of the user of this standard to establish appropriate safety practices and to determine the applicability of regulatory limitations prior to use.
Keywords
Binding sites; Construction-textile fabr/fibers; Loop length; Mass per unit area; Pile floor coverings; Thickness-textile fabr/fibers; Weight per unit area; pile yarn floor covering construction, testing; ICS Number Code 97.150 (Floor coverings)
To find similar documents by ASTM Volume:
07.01 (Textiles (I): D76 - D4391)
To find similar documents by classification:
59.080.60 (Textile floor coverings)
97.150 (Non-textile floor coverings Textile floor coverings, see 59.080.60)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D418-93
Revision Level
1993 EDITION
Status
Superseded
Modification Type
Withdrawn
Publication Date
May 12, 1993
Document Type
Test Method
Page Count
26 pages
Committee Number
D13.21