ASTM-D4285 › Standard Test Method for Indicating Oil or Water in Compressed Air
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method is used to determine the presence of oil or water in compressed air used for abrasive blast cleaning, air blast cleaning, and coating application operations.
1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 4.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
2.1 Clean compressed air is required to prevent contamination of coating materials and surfaces being prepared for coating. This test method is a visual examination technique for determining oil or water in compressed air. Other types of contamination may require additional analytical techniques for detection.
Keywords
compressed air; oil and water in compressed air;
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
23.140 (Compressors and pneumatic machines Compressed air, see 71.100.20)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A480Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
ASTM-E18
Standard Test Methods for Rockwell Hardness of Metallic Materials
UL-94
Standard for Tests for Flammability of Plastic Materials for Parts in Devices and Appliances
Document Number
ASTM-D4285-83(2018)
Revision Level
1983 R18 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Aug. 1, 2018
Document Type
Test Method
Page Count
2 pages
Committee Number
D01.46