ASTM-D4315 Historical Revision Information
Standard Test Methods for Rubber Compounding Material - Zinc Oxide

ASTM-D4315 - 1994 R12 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Methods for Rubber Compounding Material—Zinc Oxide
ORDER

Scope

1.1 These test methods cover chemical and physical tests for zinc oxide that are considered to be important to its use in rubber compounding.

1.2 The tests appear in the following order:

TestSection
Zinc Oxide5
Lead and Cadmium6
Sulfur7
Heat Loss8
Surface Area9
Sieve Residue10

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use For specific precautions, see 5.2.

Significance and Use

These test methods may be used for quality control of zinc oxide used as a compounding material and for research and development studies where zinc oxide is used in a rubber mix.

Keywords

chemical and physical tests for zinc oxide; heat loss; lead and cadmium in zinc oxide; sieve residue; sulfur in zinc oxide; surface area; zinc oxide; zinc oxide percent; Chemical analysis--rubber chemicals/materials; Lead/cadmium (in zinc oxide); Residue; Rubber compounding materials; Sieve analysis--rubber; Sulfur--rubber; Surface analysis--rubber chemicals/materials; Zinc oxide (ZnO); ICS Number Code 83.040.20 (Rubber compounding ingredients)

To find similar documents by ASTM Volume:

09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)

To find similar documents by classification:

83.040.20 (Rubber compounding ingredients Including carbon black, kaolin clay, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D4315-94(2012)

Revision Level

1994 R12 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

June 15, 2012

Document Type

Test Method

Page Count

3 pages

Committee Number

D11.20