ASTM-D4498 › Standard Test Method for Heat-Fail Temperature in Shear of Hot Melt Adhesives (Withdrawn 2021)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method is intended to determine the temperature at which specimens bonded with hot melt adhesive delaminate under static load in shear.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 Heat-fail temperature establishes a limiting temperature above which the adhesive is not to be exposed in service under shear load.
Keywords
heat fail temperature; hot-melt adhesive; shear ;
To find similar documents by ASTM Volume:
15.10 (Packaging; Flexible Barrier Packaging)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-D3363Standard Test Method for Film Hardness by Pencil Test
IPC-SM-840
Qualification and Performance Specifiation of Permanent Solder Mask and Flexible Cover Materials
ASTM-E100
Standard Specification for ASTM Hydrometers
Document Number
ASTM-D4498-07(2015)
Revision Level
2007 R15 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Nov. 1, 2015
Document Type
Test Method
Page Count
3 pages
Committee Number
D10.14