ASTM-D4770 › Standard Test Method for Appearance and Integrity of Highloft Batting After Refurbishing (Withdrawn 2008)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers procedures for determining the tactile appearance and integrity of a highloft nonwoven batting after machine washing or drycleaning when tested in a finished product or a panel assembly simulating the construction of the finished product.
1.2 This test method is not intended for use on wool/wool blend and cotton/cotton blend batting and needle-punched structures.
1.3 This test method provides the values in both SI units and inch-pound units. "Inch-pound units" is the technically correct name for the customary units used in the United States. "SI units" is the technically correct name for the system of metric units known as the International System of Units. The values stated in either system of units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining in any way.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method is used to determine the integrity of the batting or to identify the need for an alternative fiberfill batting or construction technique to meet performance requirements. Maintaining batting integrity is important to the insulating properties and appearance retention over the life of the item.
Keywords
batting; batting highloft; highloft; integrity; ICS Number Code 59.080.01 (Textiles in general)
To find similar documents by ASTM Volume:
07.02 (Textiles (II): D4393 - latest)
To find similar documents by classification:
59.080.01 (Textiles in general Including colour fastness of textiles)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4770/D4770M-00(2007)
Revision Level
2000 R07 EDITION
Status
Superseded
Modification Type
Withdrawn
Publication Date
Jan. 1, 2007
Document Type
Test Method
Page Count
3 pages
Committee Number
D13.90