ASTM-D5 › Historical Revision Information
Standard Test Method for Penetration of Bituminous Materials
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers determination of the penetration of semi-solid and solid bituminous materials.
1.2 The needles, containers and other conditions described in this test method provide for the determinations of penetrations up to 500.For guidance in preparing and testing emulsion residue specimens for this test method, please refer to Section 35 of Test Method D 244.
1.3 The values stated in SI units are to be considered standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
The penetration test is used as a measure of consistency. Higher values of penetration indicate softer consistency.
Keywords
asphalt; bitumen; penetration; ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products)
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
93.080.20 (Road construction materials Including asphalts, road pavements, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5-06e1
Revision Level
2006(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Feb. 1, 2006
Document Type
Test Method
Page Count
4 pages
Committee Number
D04.44