ASTM-D5011 › Historical Revision Information
Standard Practices for Calibration of Ozone Monitors Using Transfer Standards
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These practices describe means for calibrating ambient, workplace or indoor ozone monitors, using transfer standards.
1.2 These practices describe five types of transfer standards: (A) Analytical instruments (B) Boric acid potassium iodide (BAKI) manual analytical procedure (C) Gas phase titration with excess nitric oxide (D) Gas phase titration with excess ozone (E) Ozone generator device.
1.3 These practices describe procedures to establish the authority of transfer standards: qualification, certification, and periodic recertification.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 8 for specific precautionary statements.
Keywords
boric acid titration; gas phase titration; ozone; primary standard; transfer standard; ICS Number Code 13.040.01 (Air quality in general)
To find similar documents by ASTM Volume:
To find similar documents by classification:
13.040.01 (Air quality in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5011-92(2003)
Revision Level
1992 R03 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 1, 2003
Document Type
Practice
Page Count
28 pages
Committee Number
D22.03