ASTM-D5090 Standard Practice for Standardizing Ultrafiltration Permeate Flow Performance Data (Withdrawn 2016)

ASTM-D5090 - 2007 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Standardizing Ultrafiltration Permeate Flow Performance Data (Withdrawn 2016)
ORDER

Scope

1.1 This practice covers the standardization of permeate flow for ultrafiltration (UF) systems.

1.2 This practice is applicable to natural waters including brackish waters, seawaters, and ultrapure waters including those used in power generation and microelectronics and pharmaceuticals production. It is not necessarily applicable to waste waters.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

During the operation of a UF system, conditions including pressure and temperature can vary, causing permeate flow to change (see Note 1). To effectively evaluate system performance, it is necessary to compare permeate flow data at the same conditions. Since data may not always be obtained at the same conditions, it is necessary to convert the UF data obtained at actual conditions to a set of constant conditions, thereby standardizing the data. The user of this practice determines the standard conditions. This practice gives the procedure to standardize UF data on pure water only.

Note 1—Feed concentration, crossflow velocity, and both device and total system recovery will also influence permeate rate, especially when operating on other than pure water. This practice does not address those system conditions.

This practice can be used for systems which contain spiral-wound, tubular, plate and frame, and hollow fiber devices.

This practice can be used for a single-element or a multi-element system. However, if the UF system is staged, standardize the permeate flow and salt passage for each stage separately. This requires pressure readings at the feed inlet and concentrate outlet of each stage.

This practice is applicable for UF systems with no significant leaks between the feed/concentrate and permeate streams.

This practice assumes no significant osmotic pressure differential (Δπ) exists in the UF system under the actual operating conditions. Differential osmotic pressure will reduce the permeate rate relative to operation on pure water.

The user of this practice should be aware that fouled UF devices will produce less permeate flow than nonfouled devices, and may wish to perform flushing, chemical, or mechanical cleaning, or combination thereof, prior to determining the permeate flow performance of the device.

Keywords

nanofiltration; particulates; permeate; UF; ultrafiltration; ICS Number Code 11.040.20 (Transfusion, Infusion); 17.120.10 (Flow in closed conduits)

To find similar documents by ASTM Volume:

11.02 (Water (II))

To find similar documents by classification:

11.040.20 (Transfusion, infusion and injection equipment Including blood packs Syringes, needles and catheters, see 11.040.25)

17.120.10 (Flow in closed conduits Gas meters in buildings, see 91.140.40 Water meters in buildings, see 91.140.60)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D5090-07

Revision Level

2007 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

June 15, 2007

Document Type

Practice

Page Count

2 pages

Committee Number

D19.08