ASTM-D5114 Standard Test Method for Laboratory Froth Flotation of Coal in a Mechanical Cell

ASTM-D5114 - 1990 R18(E1) EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Laboratory Froth Flotation of Coal in a Mechanical Cell
ORDER

Price:

$63.00        


Want this as a site license?

Scope

1.1 This test method covers a laboratory procedure for conducting a single froth flotation test on fine coal (that is, nominal top size of 600 μm (No. 30 U.S.A. Standard Sieve Series) or finer) using a defined set of starting point conditions for the operating variables.

1.2 This test method does not completely cover specific procedures for the investigation of flotation kinetics. Such a test is specialized and highly dependent upon the objective of the data.

1.3 Since optimum conditions for flotation are usually not found at the specified starting points, suggestions for development of grade/recovery curves are given in Appendix X1. Such a procedure is very case-specific and involves running a series of flotation tests in which some of the operating variables are changed in order to optimize conditions for either yield or grade.

1.4 Laboratory flotation results need not be representative of the flotation response of coal in full-scale situations, but a consistent baseline can be established against which full-scale performance can be compared.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.6 Material Safety Data Sheets (MSDS) for reagents used are to be obtained from suppliers who are to be consulted before work with any chemicals used in this test method.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Significance and Use

4.1 This test method uses specific starting point conditions for the froth flotation response to accomplish the following:

4.1.1 Assess responses of one or more coals or blends of coal, and

4.1.2 Evaluate and determine froth flotation circuit performance.

Keywords

collector; flotation; flotation cell; froth flotation; frother; froth paddles; mechanical cell; pulp level; slurry level; starting point conditions ;; ICS Number Code 73.040 (Coals)

To find similar documents by ASTM Volume:

05.06 (Gaseous Fuels; Coal and Coke)

To find similar documents by classification:

73.040 (Coals Including lignites Coal products, see 75.160.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D5114/D5114M-90(2018)e1

Revision Level

1990 R18(E1) EDITION

Status

Current

Modification Type

Editorially changed

Publication Date

March 7, 2019

Document Type

Test Method

Page Count

7 pages

Committee Number

D05.07