Document Center is acquired by Nimonik

Scope

1.1 This test method covers the procedure for collection of a series of 20 gross samples for analyses. The results of analysis, when averaged, are deemed representative of the lot or a production stream for a 1-month period.

1.2 This test method may be used to determine fuel quality on other than a monthly basis if 20 gross samples are gathered, analyzed and averaged.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 7.

Significance and Use

This test method is available to producers and users of RDF as a means of determining thermal characteristics of RDF produced over a 1-month production period for purposes of contract adjustment.

Keywords

collection; samples; fuel; sample analysis; ICS Number Code 75.160.10 (Solid fuels)

To find similar documents by ASTM Volume:

11.04 (Waste Management)

To find similar documents by classification:

75.160.10 (Solid fuels Including coal products, coke, peat, wood, derivatives of coal pyrolysis, etc. Coals, see 73.040)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.