ASTM-D5132 › Historical Revision Information
Standard Test Method for Horizontal Burning Rate of Polymeric Materials Used in Occupant Compartments of Motor Vehicles
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method is intended for use as a small-scale laboratory screening procedure for comparing the relative horizontal burning rates of flexible cellular and rubber materials used in the occupant compartments of motor vehicles.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard should be used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions and should not be used to describe or appraise the fire-hazard or fire-risk of materials, products, or assemblies under actual fire conditions. However, the results of this test may be used as elements of a fire-hazard assessment or a fire-risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard or fire risk of a particular end use.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 7.
Keywords
Burning characterist-rubber/cellular materials; Fire testing-rubber/cellular materials; Flexible cellular materials; Horizontal burning; Ignition-rubber/cellular materials; Motor vehicles; Rubber-general; Small-scale burning tests; horizontal burning rate-flexible cellular/rubber materials used in; occupant compartments of motor vehicles, test; ICS Number Code 43.040.60 (Bodies and body components); 83.060 (Rubber); 83.100 (Cellular materials)
To find similar documents by ASTM Volume:
To find similar documents by classification:
13.220.40 (Ignitability and burning behaviour of materials and products)
65.060.10 (Agricultural tractors and trailed vehicles)
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5132-93
Revision Level
1993 EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
Sept. 15, 1993
Document Type
Test Method
Page Count
4 pages
Committee Number
D20.30